Guess it won't hurt to post it here too, so here it goes: After 11 months of work, I'm proud to release my first amp simulator: NRR1 Main features − Dynamic 12AX7 / ECC83 coupled triode stages analog modeling − Three channels: clean, rhythm and lead, each with fully separated controls − Selectable Mono / Stereo processing support − Selectable oversampling rate (up to 8x) − Global input / output level controls − Double precision floating point operations support − Fully automatable controls Fully coded in C++ using the Steinberg VST SDK 2.4 GUI Front: GUI Rear: Alternative GUI front: Alternative GUI rear: Make sure to read the manual, expecially the part about input / output levels and volume controls. Follow the instructions to install it (just copy the file into your VST folder), use the NRR1_NoSSE.dll file only if you have a really old machine without SSE support. DO NOT COPY BOTH DLLs INTO YOUR VST FOLDER TO AVOID POSSIBLE DAW ISSUES ON PLUGIN RECOGNIZING I'd like to thank, once again, LePou and Onqel for their help and suggestions and for all the interesting discussions we had about analog modeling. Thanks to Junior Paiz too for his tests and feedback. Download link: http://www.igniteamps.com/audioplugins/ignite_amps_nrr1_1_0_0.zip Alternative GUI version: http://www.igniteamps.com/audioplugins/ignite_amps_nrr1_1_0_0_alternative_gui.zip Contact: (for any issue with download, let me know) If you're registered one guitarampmodeling, here is the thread with some clips: http://www.guitarampmodeling.com/viewtopic.php?f=1&p=61560#p61560 Enjoy NOTE: remember that this plugin is a preamp simulator, so you'll need to use a cabinet simulation after it. Best to use an Impulse Response based plugin, like LeCab from LePou.